Hydro/Ceramic

For surface with direct water contact

For vertical and horizontal surfaces

For positive/negative pressure ≤ 1,5bar

High flexibile

Brindging fine cracks

PRODUCTS > Waterproofing and tile laying products

BK-HidroStop 5/5

Flexible two-component waterproofing coating

USE

CHARACTERISTICS

PACKAGE

Two-component, waterproofing, flexible polymer-cement coating for vertical and horizontal protection of surfaces from moisture. It is used for waterproofing potentially damp rooms such as kitchens, bathrooms, showers, swimming pools, basements, terraces, etc. It is intended for both indoor and outdoor use, suitable for positive and negative water pressure up to ≤1.5 bar.

Preparation and application :

The substrate to which BK-HidroStop 5/5 is applied must be solid, dust-free, and free of grease, mold, and loosely bonded parts. Before applying waterproofing, it is advisable to apply the BK-Ultra Prime primer, diluted according to the instructions. In the case of old and unevenly absorbent substrates, as well as porous, highly absorbent substrates, the substrate must be coated with diluted BK-Ultra Prime at least 4 hours before waterproofing. For peeled-off, worn, and/or dusty surfaces, all loosely bonded layers must be removed and then impregnated with BK-Penetrat. Concrete surfaces must be thoroughly washed with hot water to remove impurities and then coated with BK-Beton Kontakt. The preparation of the coating is performed by adding powder component A to liquid component B, with stirring until complete homogenization. Allow the compound to rest for about 5 minutes and stir again. Use the prepared compound within 1 hour. The coating is applied by brush in two coats (if needed, in three coats) using crossing motions until the surface is completely covered. The thickness of one layer is approximately 1 mm, and the second layer is applied after the previous one has hardened. The waterproofing coating should be protected from rapid drying (sun, wind). After 12 hours from the application of the last layer, the surface is ready for laying ceramics (for gluing, use flexible adhesives SiproFix BK-110 Flex, BK-160 Super Flex, BK-155 Rapid White, BK-170 Elastic, or BK-160 White). See the product datasheet for more detailed instructions.

Application temperature :

From +5°C to +25°C.

Shelf life and storage :

12 months in original packaging in dry room on pallets.

Consumption :

Approximately 1.4kg/m²/mm, depending on the quality of the substrate.

10kg